Difference between revisions of "VT3000 - Install Wireless Tone Audio Module"
Jump to navigation
Jump to search
SupportAdmin (talk | contribs) |
SupportAdmin (talk | contribs) |
||
Line 15: | Line 15: | ||
'''1.''' Mount within 6 feet of electrical outlet. | '''1.''' Mount within 6 feet of electrical outlet. | ||
<gallery widths= | <gallery widths=400 heights=240> | ||
File: | File:Install_Tone1.gif.png | ||
</gallery> | </gallery> | ||
'''2.''' | '''2.''' Plug in the power cord to the electrical outlet. | ||
<gallery widths= | <gallery widths=400 heights=240> | ||
File: | File:Install_PCS2.gif.png | ||
</gallery> | </gallery> | ||
'''3.''' | '''3.''' Note Mesh Address on the Module. | ||
<gallery widths= | <gallery widths=400 heights=240> | ||
File: | File:Install_Tone2.gif.png | ||
</gallery> | </gallery> | ||
'''4.''' | '''4.''' Open VT3000 Core Software go to Diagnostics - Device Status. | ||
<gallery widths= | <gallery widths=400 heights=240> | ||
File: | File:Install_PSM7.gif | ||
</gallery> | </gallery> | ||
'''5.''' Find the Audio Device Mesh Address in the Address field - select Options link on the right. | |||
<gallery widths=400 heights=240> | |||
File:Install_PSM8.gif | |||
</gallery> | |||
'''6.''' Select a Configuration from the New Configuration field - select Update Configuration button. | |||
<gallery widths=400 heights=240> | |||
File:Install_PSM10.gif | |||
</gallery> | |||
Revision as of 19:46, 25 October 2018
Overview
If you have purchased a new Tone Audio Module for your existing system please follow the steps below. If this is a new system, please ensure that you have the control unit installed with the coordinator operating normally.
Unpack
You will have the following component after unpacking:
Instructions
1. Mount within 6 feet of electrical outlet.
- Install Tone1.gif.png
2. Plug in the power cord to the electrical outlet.
- Install PCS2.gif.png
3. Note Mesh Address on the Module.
- Install Tone2.gif.png
4. Open VT3000 Core Software go to Diagnostics - Device Status.
5. Find the Audio Device Mesh Address in the Address field - select Options link on the right.
6. Select a Configuration from the New Configuration field - select Update Configuration button.
Step by Step Guides
Click Here for a guide on using the Audio Module.