VT3000 - Install Wireless Tone Audio Module
Revision as of 14:00, 22 August 2018 by SupportAdmin (talk | contribs)
Overview
If you have purchased a new Tone Audio Module for your existing system please follow the steps below. If this is a new system, please ensure that you have the control unit installed with the coordinator operating normally.
Unpack
You will have the following component after unpacking:
Instructions
1. Mount within 6 feet of electrical outlet.
2. Note Mesh Address on the Module - plug in power cord.
3. Open VT3000 Core Software go to Diagnostics - Device Status. Find the Audio Module using the mesh address.
4. Select Options - select Configuration - select a configuration for the device - select Update Configuration.
Step by Step Guides
Click Here for a guide on using the Audio Module.