VT3000 - Install Wireless Tone Audio Module
Revision as of 20:25, 7 November 2018 by SupportAdmin (talk | contribs)
Overview
If you have purchased a new Tone Audio Module for your existing system please follow the steps below. If this is a new system, please ensure that you have the control unit installed with the coordinator operating normally.
Unpack
You will have the following component after unpacking:
Instructions
Select EXPAND to view an Animated Graphic for the step.
Step 1: Mount Module within 6 feet of electrical outlet. |
Step 2: Plug in the power cord to the electrical outlet. |
Step 3: Look at the bottom of the Audio Module - make note of the Mesh Address. |
Step 4: Open VT3000 Core Software select Diagnostics - select Device Status. |
Step 5: Find the Audio Module's Mesh Address in the Address field - select Options link on the right. |
Step 6: Select Configuration. |
Step 7: Select a Device Configuration from the New Configuration field - select Update Configuration button. |
Step by Step GuidesClick Here for a guide on using the Audio Module.
Having Trouble? |