Difference between revisions of "VT3000 Outputs"
SupportAdmin (talk | contribs) |
SupportAdmin (talk | contribs) |
||
| Line 12: | Line 12: | ||
==Pager== | ===On-Site Pager=== | ||
Use this type of output if the system has a paging transmitter attached and installed. VersaGold pagers are required, the user will need the Cap Code of each pager – a Cap Code is a 7-digit number found on a sticker placed on the back side of a VersaGold pager. If there is no sticker attached to the pagers use [[VT3000 - Program a Pager - Capcode]] to access or program the Cap Code. | Use this type of output if the system has a paging transmitter attached and installed. VersaGold pagers are required, the user will need the Cap Code of each pager – a Cap Code is a 7-digit number found on a sticker placed on the back side of a VersaGold pager. If there is no sticker attached to the pagers use [[VT3000 - Program a Pager - Capcode]] to access or program the Cap Code. | ||
===Email Address=== | |||
Use this type of output if the system has been set up to send emails. If you are not sure about the email settings use | |||
Revision as of 22:02, 22 August 2017
Output
Any device the VT3000 system has access to notify when an alarm/call is made from a device/module. All outputs must be setup before it can be added to a route. Outputs are limited to Pagers, Emails, Text Messages, Radio Channels and Phone Numbers.
Basic Functionality
Each output has a specific icon representing it in the Add New list on the Outputs page.
On-Site Pager
Use this type of output if the system has a paging transmitter attached and installed. VersaGold pagers are required, the user will need the Cap Code of each pager – a Cap Code is a 7-digit number found on a sticker placed on the back side of a VersaGold pager. If there is no sticker attached to the pagers use VT3000 - Program a Pager - Capcode to access or program the Cap Code.
Email Address
Use this type of output if the system has been set up to send emails. If you are not sure about the email settings use