VT3000 - Install a Repeater

---

---

Overview A Repeater Module is designed to extend the signal of the Mesh System. A repeater consists of 2 pieces, a Module & an Antenna. Installation for a Repeater is simple when done correctly, please use this guide to install your Repeater.

Requirements See Requirements Here 1. The VT3000 Core Software installed and running on your system. 2. Coordinator connected and communicating with your VersaCall system. 3. Repeater Module w/Antenna. 4. Available 110VAC outlet at the Repeater mounting location.

Hardware Components

---

---

Step 1. Attach the Antenna to the module. Be mindful to not Over Tighten - screw on until it stops not beyond.

---

Step 2. Place the Repeater within 6 feet of an electrical outlet - DO NOT MOUNT.

---

Step 3. Plug Power Cord into an outlet.

---

Step 4. All the LED's on the repeater will blink for approximately 3 minutes - this is a signal test.

---

Step 5. After the signal test - the Green LED should be solid with Red and Yellow LED's off. If the Green LED is solid you can mount the Repeater in this location. NOTE: If the Red or Yellow LED is on - move the Repeater closer to the coordinator and repeat until a solid Green LED is shown on the module.

---

---

Select a Guide Here Create/Add a Repeater Configuration to VT3000 Core Software

---

---