VT3000 - Configure a Repeater

---

---

Overview A Repeater is used to extend the mesh network signal. If signal strength is weak or communications are dropping, you can use a repeater to extend/strengthen the signal in the facility.

Requirements See Requirements Here 1. The VT3000 Core Software installed and running on your system. 2. A Coordinator must be setup, powered and communicating with the VT3000 Core Software. 3. A Repeater powered and communicating with the VT3000 Software.

---

---

Step 1. Open the VT3000 web interface – select VT3000 Core Software - log in – select Configuration – select Devices. Configuration Devices

---

Step 2. Select the Repeater icon in the Add New menu.

---

Step 3. Enter a name for the Repeater on the Properties tab.

---

Step 4. Select Save & Exit.

---

Step 5. The configuration will need to be sent to the device. CLICK HERE for instructions. The instructions show a PSM - the steps are the same for a Repeater.

---

---

Select a Guide Here Instructions on Installing a Repeater

---

---