VT3000 - Update Configuration - TIM, PSM, BSC

---

---

Overview Configurations for Devices are sent over the Wireless Mesh infrastructure. Anytime a configuration is changed in the VT3000 software, the device must be updated. When a new device is added to the system, a configuration must be created and sent to the device. The instructions in this guide will work for a Switch Contact Module, Wireless Controls Module, BSC, TIM & PSM. If you have a Call Station, please use one of the Update Configuration methods found on the Categories - Call Station page.

Requirements See Requirements Here 1. The VT3000 Core Software installed and running on your system. 2. At least one Coordinator setup, powered and communicating with the VT3000 Core Software. 3. At least one Switch Contact, Wireless Controls Module, BSC, TIM or PSM powered & communicating with the system. 4. At least one Configuration setup in the VT3000 Core Software for the device.

---

---

Video

---

---

Step 1. Open the VT3000 web interface – log in – select Diagnostics – select Device Status. Diagnostics Device Status

---

Step 2. If you are updating a configuration on a Device that was previously configured, select the Update link next to the device name.

---

Step 3. If this is an unconfigured/new device, find the Device in the list using the Mesh Address. Once you find the Device in the list, click on the Options link on the right side of the screen.

---

Step 4. Select Configuration.

---

Step 5. The Configuration options will show on the screen, below is an explanation of each field. a. Current Configuration – will show as Unknown. b. Sync Key – system setting not related to the configuration. c. New Configuration – using the down arrow - select a configuration for the Call Station. d. Update Configuration – sends the configuration to the Call Station.

---

Step 6. Select the Configuration that you want to use for this Device - select the Update Configuration button.

---

Step 7. Select the Return to Device Status button.

---

Step 8. The Update will take 1 to 2 minutes. When the page refreshes the Device will show the correct Device Name.

---

---

Select a Guide Here Change the ISO Code using the Micro SD Card - BSC TIM PSM Change the ISO Code using the Touch Screen - BSC TIM PSM Change the ISO Code using the VT3000 Software - BSC TIM PSM Change the ISO Code on a Call Station using the Alarm buttons Change the ISO Code on a Call Station using the Micro SD Card Change the ISO Code on a Call Station using the VT3000 Software Update the Configuration on a Battery Power Call Station Update the Configuration on a Powered Call Station Device Status Overview

---

---