VT3000 - Update Configuration - Powered Call Station

---

---

Overview Configurations for Devices are sent over the Wireless Mesh infrastructure. Anytime a configuration is changed in the VT3000 software, the device must be updated. When a new device is added to the system, a configuration must be created and sent to the device. NOTE: These instructions are for powered Call Stations NOT battery power Call Stations.

Requirements See Requirements Here 1. The VT3000 Core Software installed and running on your system. 2. A Coordinator setup, powered and communicating with the VT3000 Core Software. 3. At least one Call Station powered & communicating with the system. 4. A Call Station Configuration setup in the VT3000 Core Software.

---

---

Video

---

---

Step 1. Open the VT3000 web interface – log in – select Diagnostics – select Device Status. Diagnostics Device Status

---

Step 2. If you are updating a configuration on a Call Station that was previously configured, select the Update link next to the device name.

---

Step 3. If this is an unconfigured/new device, find the Call Station in the list using the Mesh Address. Once you find the Call Station in the list, click on the Options link on the right side of the screen.

---

Step 4. Select Configuration.

---

Step 5. The Configuration options will show on the screen, below is an explanation of each field. a. Current Configuration – will show as Unknown. b. Sync Key – system setting not related to the configuration. c. New Configuration – using the down arrow - select a configuration for the Call Station. d. Update Configuration – sends the configuration to the Call Station.

---

Step 6. Select the Configuration that you want to use for this Call Station - select the Update Configuration button.

---

Step 7. Select the Return to Device Status button.

---

Step 8. The Update will take 1 to 2 minutes. When the page refreshes the Call Station will show the correct Device Name.

---

---

Select a Guide Here Installation Instructions for a Battery Call Station Installation Instructions for a Powered Call Station Add a Call Station Configuration Update the Configuration on a Battery Call Station Update the Firmware on a Battery Call Station - Wireless Update the Firmware on a Powered Call Station - Wireless Update the Firmware on a Call Station - Manually Install/Attach a Stack Light to a Call Station Configure/Setup Light Stack on the Call Station Configuration Setup the Use of the Light(s) on the Call Station Configuration Overview of the Device Status Page Change ISO Code on a Call Station using the # 1 - # 4 Buttons Change ISO Code on a Call Station using the Micro SD Card Change ISO Code on a Call Station using VT3000 Core Software Wirelessly Perform a Coverage Test on a Powered Call Station Perform a Coverage Test on a Battery Powered Call Station

---

---