VT3000 - Install Call Station - Battery

---

---

Overview Call Stations come as either Battery Powered or 110VAC Powered. This guide will explain how to install a Battery Powered Call Station.

Requirements See Requirements Here 1. The VT3000 Core Software installed and running on your system. 2. Coordinator connected and communicating with your VersaCall system. 3. Call Station Module. 4. Phillips head screw driver. 5. Two "C" Batteries.

Hardware Components

---

---

Step 1. Remove the 4 screws from the cover of the Call Station.

---

Step 2. Separate the cover from the box - place the supplied batteries into the battery holder.

---

Step 3. Place the cover on the box - hand tighten all 4 screws on the Call Station.

---

Step 4. Look at the bottom of the Call Station - make note of the Mesh Address.

---

Step 5. Inspect the LED cluster on the front of the Call Station - the Green LED blinking means a connection to the system has been established.

---

Step 6. For Instructions on sending a Configuration to a Call Station - Click Here.

---

---

Select a Guide Here Installation Instructions for a Powered Call Station Add a Call Station Configuration Update the Configuration on a Battery Call Station Update the Configuration on a Powered Call Station Update the Firmware on a Battery Call Station - Wireless Update the Firmware on a Powered Call Station - Wireless Update the Firmware on a Call Station - Manually Install/Attach a Stack Light to a Call Station Configure/Setup Light Stack on the Call Station Configuration Setup the Use of the Light(s) on the Call Station Configuration Change ISO Code on a Call Station using the # 1 - # 4 Buttons Change ISO Code on a Call Station using the Micro SD Card Change ISO Code on a Call Station using VT3000 Core Software Wirelessly Perform a Coverage Test on a Powered Call Station Perform a Coverage Test on a Battery Powered Call Station

---

---