VT3000 - Update Firmware - Powered Call Station - Wireless

---

---

Overview Firmware updates are included with Software Updates. This guide explains how to update a Powered Call Station Firmware using Wireless Mesh infrastructure. NOTE: The file transfer will take about 10 minutes to upload to the call station. Keeping this in mind, only update 1 call station at a time. If multiple units are selected, the transmission times will increase and there is a higher risk of file corruption. The best practice is to perform the update during slow times to take strain off the Mesh infrastructure during the normal work day.

Requirements See Requirements Here 1. The VT3000 Core Software installed and running on your system. 2. A Coordinator must be setup, powered and communicating with the VT3000 Core Software. 3. At least one Powered Call Station communicating with the system.

---

---

Step 1. Open the VT3000 web interface – select VT3000 Core Software - log in – select Diagnostics – select Device Status. Diagnostics Device Status

---

Step 2. Find the Call Station with a green update icon - select the Options link for the Call Station.

---

Step 3. Select Firmware.

---

Step 4. Select the Update Firmware button.

---

Step 5. A warning screen will show - select OK.

---

Step 6. Select the Return to Device Status button.

---

Step 7. To Monitor the file transfer - select the Details link for the Call Station being updated.

---

Step 8. Select File Transfers.

---

Step 9. The transfer data is shown with file size, percentage complete and other information - select Return to Device Status when transfer is complete.

---

Step 10. The Call Station will reboot and beep for a few seconds. The Call Station will now show on the Device Status page without the green update icon.

---

---

Select a Guide Here Installation Instructions for a Battery Call Station Installation Instructions for a Powered Call Station Add a Call Station Configuration Update the Configuration on a Battery Call Station Update the Configuration on a Powered Call Station Update the Firmware on a Battery Call Station - Wireless Update the Firmware on a Call Station - Manually Install/Attach a Stack Light to a Call Station Configure/Setup Light Stack on the Call Station Configuration Setup the Use of the Light(s) on the Call Station Configuration Change ISO Code on a Call Station using the # 1 - # 4 Buttons Change ISO Code on a Call Station using the Micro SD Card Change ISO Code on a Call Station using VT3000 Core Software Wirelessly Perform a Coverage Test on a Powered Call Station Perform a Coverage Test on a Battery Powered Call Station

---

---