Call Support at 858-677-6766 ext. 210
The Computer or Server can be a device provided by VersaCall or a device provided by the customer.
|
The VT3000 software will be installed on this device.
|
Any VersaCall Hardware will need to be attached to the device by a physical port or through a network connection.
|
|
|
|
Control Unit - Computer/Server
|
|
SERVERS: Built to the dimensions provided by the customer so that it can be mounted in an existing server rack.
|
NOTE: Control Units can vary in appearance. Overall dimensions should not exceed what is show above.
Requirements
|
110v power outlet within 6 feet of placement/location.
|
If the Control Unit is going to be connected to your network, an ethernet connection should be available within a reasonable distance from the placement/location.
|
If the Control Unit is going to be connected to your network, a Static IP Address or a DHCP Reserved address must be setup.
|
Mouse , Keyboard & Monitor are not included. These will be required during the initial setup.
|
Specifications
|
Dimensions - 10.5” (W) x 13” (L) x 4” (H)
|
(1) 6’ Power Cord included
|
(1) Ethernet Cable (not included) when connecting to your network.
|
|
|
|
Select the appropriate link below for Instructions on Installation
|
Select the appropriate link below for a How To Guide
|