VT3000 - Install Wireless Light Module

---

---

Overview A Wireless Light Module is used for signaling issue via colored lights where other VersaCall modules are not located. An example would be a light stack mounted in the Maintenance department away from the production floor. This guide will explain how to install and configure the device.

Requirements See Requirements Here 1. The VT3000 Core Software installed and running on your system. 2. Coordinator connected and communicating with your VersaCall system. 3. Available 110VAC outlet at the Wireless Light mounting location. 4. Wireless Lights Module. 5. A Wireless Lights Configuration setup in the VT3000 Software

Hardware Components

---

---

Step 1. Mount Module within 6 feet of electrical outlet.

---

Step 2. Use the attached bracket to mount the module.

---

Step 3. Plug in the power cord for the module.

---

Step 4. Note Mesh Address on the Module.

---

Step 5. Open VT3000 Core Software go to Diagnostics - Device Status.

---

Step 6. Find the Wireless Device Mesh Address in the Address field - select Options link on the right.

---

Step 7. Select a Configuration from the New Configuration field - select Update Configuration button.

---

Select a Guide Here Instructions on Installing a Wireless Light Module Add a Wireless Light Configuration to VT3000 Core Software Instructions on Configurating Devices to use a Wireless Light Module

---

---