Difference between revisions of "VT3000 - Install Wireless Tone Audio Module"
Jump to navigation
Jump to search
SupportAdmin (talk | contribs) |
SupportAdmin (talk | contribs) |
||
Line 91: | Line 91: | ||
|[[VT3000 - Adjust Volume - Audio Module|Instructions on Adjusting the Tone/Melody Volume]] | |[[VT3000 - Adjust Volume - Audio Module|Instructions on Adjusting the Tone/Melody Volume]] | ||
|- | |- | ||
|[[VT3000 - Play Audio on Wireless Audio Device|Instructions on | |[[VT3000 - Play Audio on Wireless Audio Device|Instructions on Configuring Devices to Play a Melody on a Wireless Audio Module (Tone/MP3)]] | ||
|} | |} | ||
|valign="top" | | |valign="top" | |
Revision as of 20:58, 22 June 2021
Overview
If you have purchased a new Tone Audio Module for your existing system please follow the steps below. If this is a new system, please ensure that you have the control unit installed with the coordinator operating normally.
Requirements
1. VT3000 Core Software installed and running on your system.
2. A Coordinator plugged in and running on your system.
3. An Open Plug on a 110V Outlet.
Unpack
You will have the following component after unpacking:
Instructions
Select EXPAND to view an Animated Graphic for the step.
Step 1: Mount Module within 6 feet of electrical outlet. |
Step 2: Plug in the power cord to the electrical outlet. |
Step 3: Look at the bottom of the Audio Module - make note of the Mesh Address. |
Step 4: Open VT3000 Core Software select Diagnostics - select Device Status. |
Step 5: Find the Audio Module's Mesh Address in the Address field - select Options link on the right. |
Step 6: Select Configuration. |
Step 7: Select a Device Configuration from the New Configuration field - select Update Configuration button. |
|