VT3000 - Install Modem - NEW VersaCall Provided Computer

---

---

Overview The instructions below cover installing a phone modem on a new system (pre-configured by VersaCall). Our phone modem connects to a USB port on the VersaCall computer/server. An analog phone line is required for the installation - contact IT if you do not currently have a line available.

Requirements See Requirements Here 1. The VT3000 Core Software installed and running on your system. 2. Marked USB Port on the VersaCall computer/server. 3. Analog Phone line jack. This port will need to be setup by your IT Department on your phone system.

Hardware Components

---

---

Step 1. Power Off the VersaCall computer/server.

---

Step 2. Plug the USB Cable into the Phone Modem.

---

Step 3. Plug the USB Cable into the marked USB port on the VersaCall Computer/Server.

---

Step 4. Plug the analog phone line into the Line connector.

---

Step 5. Power Up/Turn On the VersaCall Computer.

---

Step 6. The LED for Power on the Modem should be solid red once the computer has booted up.

---

Step 7. Once the computer is on and you have logged in (Windows or VT3000 Web Interface), test the phone modem - Click here for Instructions.

---

---

Select a Guide Here Find the Phone Modem Properties/Settings Install a Phone Modem on New Computer - Not Provided by VersaCall Using a Phone Modem & 2-Way Radio Together Adjust the Number of Times the Message is Repeated Adjust the Volume Level for Messages Test the Modem & Phone Number Add a Phone Number to Outputs in VT3000 Core Software

---

---