VT3000 - Static IP Address (Control Unit) - Windows 7/8

From Versacall Support
Jump to navigation Jump to search
Call Now 858-677-6766 SubmitTckBtn.png EmailUsBtn.png



GeneralHeader.png

Overview
These instructions are for Windows 7 & 8 operating systems. Under the Step by Step Guide section of this page there is a link to the Windows 10 operating system. In order to access the VersaCall software from any computer on the network, the control unit must have an IP address assigned to it. If your control unit is NOT on your network, an assigned IP address is not required. Your IT department will need to issue a static IP address.


Requirements
See Requirements Here
1. The VT3000 Core Software installed and running on your system.
2. An Assigned IP Address from IT.
3. The Subnet Mask for the Static IP Address.
4. The Default Gateway for the Static IP Address.
5. The DNS Server settings for the Static IP Address.



InstructionHeader.png

Step 1.
The Network icon is generally displayed next to the Date & Time stamp on the Windows navigation bar. Right click on the icon.
3124 1.png



Step 2.
Select Open Network and Sharing Center.
3124 2.png



Step 3.
Select “Local Area Connection”.
3124 3.png



Step 4.
Select Properties.
3124 4.png



Step 5.
Select Internet Protocol Version 4 (highlighted) - select Properties.
3124 5.png



Step 6.
Select “Use the following IP address” and “Use the following DNS server addresses” (DNS selection if required). Enter the IP Address, Subnet Mask and Default Gateway. If you selected to use a specific DNS server - enter the Preferred and Alternate DNS server address - select OK - close all open Windows.
3124 6.png



Step 7.
Open an Internet browser on another computer attached to the network - enter the IP address entered in step 6 (our example 198.166.100.22) – the VT3000 Welcome page will load if correct.
3124 7.png



Step 8.
If the VT3000 welcome page does not load, please contact VersaCall for further assistance.



RelatedHowTos.png
Select a Guide Here
Hard Drive is Full on VersaCall Server/Control Unit
Cannot Log into Windows on VersaCall Server/Control Unit
Configuring a Static IP Address for the VersaCall Server/Control Unit using Windows 10
Correct Firewall Settings for the VersaCall Server/Control Unit



SearchHeader.png

 



VC Footer.png
Follow Us On LinkedIn View our Blog


Retrieved from "http://support.versacall.com/index.php?title=VT3000_-_Static_IP_Address_(Control_Unit)_-_Windows_7/8&oldid=9659"