VT3000 - Switch a PC Input Module

---

---

Overview If you using a PC Input Module there may be a need to switch the location/station over to a new or different one. This may happen when there is a new station added or the wrong station has been selected. This guide will show you how to get that switched over for the operator.

Requirements See Requirements Here 1. The VT3000 Core Software installed and running on your system. 2. PC Input Module plug in installed and licensed in the VT3000 Core Software. 3. A PC Input Module configuration setup in the VT3000 Software. 4. A PC Input Module open in a browser on a Computer or Tablet.

---

---

Step 1. Go to the Computer or Tablet at the Station location. Open the PC Input Module as normal from the web browser.

---

Step 2. Click on the Change link next to the station/location name.

---

Step 3. A PIN entry screen will appear. The default PIN is 7047 - if this has been changed you will need to talk to your system supervisor to obtain the correct PIN.

---

Step 4. Enter the default PIN or the PIN provided by your system supervisor.

---

Step 5. Select the OK button on the PIN Entry screen.

---

Step 6. Select one of the Device Configurations by clicking on it so that it is highlighted.

---

Step 7. Select the Use button at the bottom of the page.

---

Step 8. The page will load showing you the PC Input Module you selected. You can now use the device by clicking on one of the available buttons.

---

---

Select a Guide Here An Overview of Device Plug In Section Instructions on Installing a Device Plug In Changing/Switching the Configuration of a PC BSC Changing/Switching the Configuration of a PC Call Station Open/Use a PC BSC on a Computer or Tablet Open/Use a PC Call Station on a Computer or Tablet Open/Use a PC Input Module on a Computer or Tablet

---

---