VT3000 - Add a Count to a PC Input Module

---

---

Overview When using a PC Input Module a Count can be added to show as a button on the screen. VersaCall refers to this type of input as a Virtual Input or Virtual Count.

Requirements See Requirements Here 1. The VT3000 Core Software installed and running on your system. 2. Software - PC Input Module plug in must be loaded in your system.

Video File:Add Count to PC Input.mkv

Instructions

Step 1. Open the VT3000 web interface – select VT3000 Core Software - log in – select Configuration – select Devices. Configuration Devices

---

Step 2. Select the PC Input Module that you want to add the Count Button to from the list - select the Edit button.

---

Step 3. Select the Virtual Inputs tab.

---

Step 4. Select the Add Input (Plus) icon from the tool box.

---

Step 5. Virtual Input Properties - Enter Count for the Description - select Count for the Type - ensure Enabled is check marked.

---

Step 6. Select Save & Exit button.

---

Step 7. Select the PC Input Module that you setup the Virtual Input on in the Steps above - select the Edit button.

---

Step 8. Select the Monitoring Points tab.

---

Step 9. Select the Add Process icon under the Monitoring Points tab if a process does not already exist.

---

Step 10. Process Properties - setup the monitoring point as shown below: Process Name - enter Work. Mode - select Process.

---

Step 11. With the Process Selected in the root - select the Add Sampler icon from the toolbox.

---

Step 12. Sampler Properties - setup the monitoring point as shown below: Sampler Name - enter Count. Mode - select Linked Sampler. Type - select Count. Trigger - select As Occurs. Input - select Count - this is the Virtual Input setup in the beginning of the guide. Color - select default.

---

Step 13. The Root should look like the image below.

---

Step 14. Select Save & Exit button.

---

Step 15. Example of what the Screen will display. Not Active - press the Start Work/Process button to enable a count. Active Count - press the Count button to add a count - press the End Work/Process button to disable the count.

---

---

Select a Guide Here Add a Count Button - BSC Add a Count Button - TIM, PSM Add a Continuous Count - TIM PSM Switch Contact Setup a Wired Input as a Count - TIM PSM Switch Contact Add a Count to a Process - TIM, PSM

---

---