Home - Coordinator

---

---

The Coordinator is the device that receives information from the devices on the plant floor. The Coordinator communicates all information from the hardware devices to the VersaCall Software. This device communicates with hardware devices over a 900MHz band. VersaCall refers to this as our Mesh Network. Coordinators can be connected to the Computer/Server via USB port or over an Ethernet connection.

---

---

Coordinator - USB

Requirements 110v power outlet within 6 feet of placement/location. Control Unit within 6 feet of placement/location. Specifications Dimensions – 3.5” (W) x 4.5” (L) x 1.5” (H) (1) 6’ Power Cord (included) (1) 6’ USB Cord (included) (1) 7” Antenna (included)

Coordinator - Remote

Requirements (2) 110v power outlets within 6 feet of placement/location (Coordinator & RS-232). Coordinator & RS-232 within 6 feet of each other. Ethernet port near the placement/location of the RS-232. RS-232 will need to be assigned a Static IP Address or a DHCP Reserved address. Specifications Coordinator Dimensions – 3.5” (W) x 4.5” (L) x 1.5” (H) RS-232 Dimensions - s" (W) x 3.25" (L) x .75" (H) (2) 6’ Power Cords (included) (1) 6’ Serial Cable (included) (1) 7” Antenna (included) (1) Ethernet Cable (not included)

Real-Port - Remote Coordinator

Requirements 110v power outlet within 6 feet of placement/location. Ethernet Port within 6 feet of placement/location. Pre-Installed Static IP Address (VersaCall) or DHCP Reserved IP Address based on the MAC Address of the Coordinator (Customer IT). Specifications Dimensions – 3.5” (W) x 4.5” (L) x 1.5” (H) (1) 6’ Power Cord (included) (1) 6’ Ethernet Cord (included) (1) 7” Antenna (included)

---

---

Select the appropriate link below for Instructions on Installation Instructions on Installing a USB type Coordinator Instructions on Installing an Ethernet/Remote Coordinator where the Coordinator & Computer/Server are on the Same Subnet Instructions on Installing an Ethernet/Remote Coordinator where the Coordinator & Computer/Server are on Different Subnets Instructions on Installing an Ethernet Connect Port X2 (Real-Port) Coordinator where the Coordinator & Computer/Server are on the Same Subnet Instructions on Installing an Ethernet Connect Port X2 (Real-Port) Coordinator where the Coordinator & Computer/Server are on Different Subnets

---

---

Select the appropriate link below for a How To Guide Instructions on how to Replace a USB Coordinator Instructions on how to get the Driver Settings for a Coordinator Setup on the System Instructions on how to Change the Current ISO Code on the Coordinator

---

---

---