VT3000 - Find Coordinator Settings

---

---

Overview If you have a need to check the Coordinator settings or if a VersaCall Technician asks you provide the settings, the instructions below will show you have to find them.

Requirements See Requirements Here 1. The VT3000 Core Software installed and running on your system. 2. A Coordinator must be setup, powered and communicating with the VT3000 Core Software.

---

---

Video

---

---

Step 1. Open the VT3000 web interface – select VT3000 Core Software - log in – select Administration – select System Settings - select Service. Administration System Settings Service

---

Step 2. Select the Coordinators tab.

---

Step 3. Select your Coordinator from the list so that it is highlighted.

---

Step 4. On the right side of the list you will see these settings for a USB Coordinator: Enabled – will be check marked to enable the device. Network Name – Coordinator Name. Driver – USB Digi Mesh 900HP. Isolation Code – this is set to 1 unless VersaCall instructs you to change it. Port – will show as USB Serial Port (COM#). The COM number will differ from the screen shot in most cases.

---

Step 5. On the right side of the list you will see these settings for a Remote Coordinator: Enabled – will be check marked to enable the device. Network Name – Coordinator Name. Driver – will be Remote DigiMesh 900HP. Isolation Code – leave this set to 1 unless VersaCall instructs you to change it. Connection Method - will be TCP Client. Address - will have the Static IP address of the RS-232 device. Port – will be set to 4000.

---

Step 6. Select the Discard & Exit button to exit the tab/page.

---

---

Select a Guide Here Install a USB Coordinator Replace a USB Coordinator Install a Remote Coordinator on the Same Subnet as the VersaCall Computer/Server Install a Remote Coordinator on a Different Subnet than the VersaCall Computer/Server Install a Real-Port Coordinator on the Same Subnet as the VersaCall Computer/Server Install a Real-Port Coordinator on a Different Subnet than the VersaCall Computer/Server Change System ISO Code

---

---