VT3000 - Install Coordinator - USB

---

---

Overview The Coordinator is the device that connects the VersaCall software running on the computer/server to the hardware modules on the plant floor. Without this device, the devices and software cannot communicate. The instructions below will show you how to Install a new Coordinator. If you are wanting to Replace an Existing Coordinator - Click Here for Instructions.

Requirements See Requirements Here 1. The VT3000 Core Software installed and running on your system. 2. Physical access to the Coordinator & VersaCall Computer/Server. 3. New Coordinator hardware.

Hardware Components

---

---

Step 1. Download the driver, you received from VersaCall Support - place the zip file on the VersaCall computer - unzip the file on the VersaCall computer.

---

Step 2. Go to the location where the zip file was extracted - open the “CDM21224_Setup” folder – run the “CDM21224_Setup.exe” file.

---

Step 3. Select Run on the first screen.

---

Step 4. If you encounter a Windows Security screen about the installation, select Yes.

---

Step 5. Select Extract on the FTDI CDM Drivers screen.

---

Step 6. Select Extract on the FTDI CDM Drivers screen.

---

Step 7. Select Accept on the License Agreement screen - select Next.

---

Step 8. Select Finish on the Completion screen.

---

Step 9. Attach the Antenna to the Coordinator - screw onto threaded stud.

---

Step 10. Plug in the USB cord to the input port on the Coordinator.

---

Step 11. Plug in the Power Cord to the input port on the Coordinator.

---

Step 12. Plug the Power Cord into an open 110V electrical outlet.

---

Step 13. Plug the USB Cord from the Coordinator into an open USB port on the back of the VersaCall computer.

---

Step 14. Plug the USB Cord from the Coordinator into an open USB port on the back of the VersaCall computer.

---

Step 15. Select the Coordinators tab on the Service Settings page.

---

Step 16. Select the Plus icon.

---

Step 17. Coordinator Properties: Enabled - place a check mark in the box to enable the device. Network Name - enter a name for the coordinator. Driver - select USB Digi Mesh 900HP. Isolation Code - leave this set to 1 unless VersaCall instructs you to change it. Port - select the COM port labeled as Digi USB Serial Port.

---

Step 18. Select Save & Exit.

---

Step 19. Select Yes on the Restart warning message. This must be done to complete the setup.

---

Step 20. Restart the VersaCall Service - Click here for Instructions.

---

---

Select a Guide Here Find Coordinator Driver Settings Replace a USB Coordinator Install a Remote Coordinator on the Same Subnet as the VersaCall Computer/Server Install a Remote Coordinator on a Different Subnet than the VersaCall Computer/Server Install a Real-Port Coordinator on the Same Subnet as the VersaCall Computer/Server Install a Real-Port Coordinator on a Different Subnet than the VersaCall Computer/Server Change System ISO Code

---

---