VT3000 - Send a New Configuration to a TIM or PSM

---

---

Overview When you add a New TIM or PSM to your system that has never been configured, you will need to send out a configuration to the device.

Requirements See Requirements Here 1. The VT3000 Core Software installed and running on your system. 2. A Coordinator must be setup, powered and communicating with the VT3000 Core Software. 3. A PSM or TIM Module Powered and communicating with the VT3000 Software. 4. A Touch Screen powered and showing the VersaCall HMI interface.

---

---

Step 1. Find & make a note of the Mesh Address on the IO Module. - plug in power to the IO Module & the Touch Screen.

Step 2. Open VT3000 Core Software select Diagnostics - select Device Status.

---

Step 3. Using the Mesh Address that you noted in Step 1 - find the Device using the Address field - select the Options link on the right once you have found it.

---

Step 4. Select Configuration.

---

Step 5. Select the down arrow on the New Configuration field. Select a Device Configuration from the list - select the Update Configuration button.

---

Step 6. Go to the Touch Screen - verify the correct module name shows in the top left corner.

---

---

Select a Guide Here Install a Battery Powered Call Station Install a Powered Call Station Install a TIM Device Install a PSM Device

---

---