VT3000 - Test - Bluetooth Signal Strength

---

---

Overview The instructions below show how to test the Bluetooth signal strength between the Touch Screen & the IO Module. The Tablet must be placed within 15 feet of the IO Module, line of site, for optimal signal strength.

Requirements See Requirements Here 1. A BSC, TIM or PSM I/O Module powered. 2. A Touch Screen powered and connected to the I/O via Bluetooth.

---

---

Step 1. On the tablet click on the 3 white squares in the top right corner.

---

Step 2. Enter the PIN - by default this is 7047 - select OK.

---

Step 3. Select Diagnostics from the menu that comes up on the screen.

---

Step 4. Select the Start Packet Test button.

---

Step 5. Under the Packet Test button there is an update status.

---

Step 6. Allow the test to run for a minimum of 50 packets - select the Stop Packet Test button.

---

Step 7. If the results are less than 100% - move the tablet closer to the IO Module and repeat the test until you get a 100% result.

---

Step . When the testing is completed - select the Back or Home icon at the bottom of the screen.

---

---

Select a Guide Here Guide on Pairing an IO with an Existing Touch Screen - BSC TIM PSM Guide on Paring an IO with a New Touch Screen - BSC TIM PSM Set the Correct Day & Time on a Touch Screen - BSC TIM PSM Test the Signal Strength of a BSC, TIM or PSM

---

---