VT3000 - Find Coordinator Settings
Revision as of 15:55, 7 September 2021 by SupportAdmin (talk | contribs)
|
|
Instructions
1. Open VT3000 web interface – log in – select Administration – select System Settings – select Service.
2. Select the Coordinators tab on the Service Settings page.
3. Select your Coordinator from the list so that it is highlighted.
4. On the right side of the list you will see these settings for a USB Coordinator:
a. Enabled – will be check marked to enable the device. b. Network Name – Coordinator Name. c. Driver – USB Digi Mesh 900HP. d. Isolation Code – this is set to 1 unless VersaCall instructs you to change it. e. Port – will show as USB Serial Port (COM#). The COM number will differ from the screen shot in most cases.
5. On the right side of the list you will see these settings for a Remote Coordinator:
a. Enabled – will be check marked to enable the device. b. Network Name – Coordinator Name. c. Driver – will be Remote DigiMesh 900HP. d. Isolation Code – leave this set to 1 unless VersaCall instructs you to change it. e. Connection Method - will be TCP Client. f. Address - will have the Static IP address of the RS-232 device. e. Port – will be set to 4000.
6. Ensure that you select Discard & Exit so that nothing is changed.