VT3000 - Find Paging Transmitter Settings

---

---

Overview If you have a need to check the Paging Transmitter settings or if a VersaCall Technician asks you provide the settings, the instructions below will show you have to find them.

Requirements See Requirements Here 1. The VT3000 Core Software installed and running on your system. 2. A Paging Transmitter (USB or Remote) setup, powered and communicating with the VT3000 Core Software.

---

---

Video

---

---

Step 1. Open the VT3000 web interface – select VT3000 Core Software - log in – select Administration – select System Settings - select Service. Administration System Settings Service

---

Step 2. Select the Paging Transmitter tab.

---

Step 3. Select your installed Paging Transmitter from the list so that it is highlighted.

---

Step 4. On the right side of the list you will see these settings for a USB Paging Transmitter. Enabled - this will be check marked indicating the transmitter is being used. Description - the name of the Paging Transmitter. Driver - this will show Salcom 12-62 - USB. Synchronization Code - by default this will show None. Do not change this setting unless instructed to do so by a VersaCall Technician. Connection Method - this will show as Serial. Port - this will show as Silicon Labs CP210x USB to UART Bridge (COM#). The COM number maybe different from the screen shot.

---

Step 5. On the right side of the list you will see these settings for a Remote Paging Transmitter. Enabled - this will be check marked indicating the transmitter is being used. Description - the name of the Paging Transmitter. Driver - this will show Salcom 12-62 - Remote. Synchronization Code - by default this will show None. Do not change this setting unless instructed to do so by a VersaCall Technician. Connection Method - this will show as TCP Client. Address - this will show the IP Address being used by the RS-232 device. Port - this will show as 4000.

---

Step 6. Select the Discard & Exit button to exit the tab/page.

---

---

Select a Guide Here Install Instructions for USB Transmitter Install Instructions for Remote Transmitter on Same Subnet Install Instructions for Remote Transmitter on Other Subnet Add a Pager Program a Pager Capcode Test Pager Coverage Set up Device Monitoring Find the Location of all VersaCall Databases Turn Debug Mode On/Off in VT3000 Core Software Control Center Location & Text to Voice Settings Location for the Coordinator Settings & Driver Setup Location for the 2-Way Radio Settings & Driver Setup Location for the Phone Modem Settings Location & Setup for the SMTP Email Server

---

---