Type – select Transition for an Alarm - contact will either be On or Off.
|
Enabled – select to enable input - this will make the input active at all times. For most configurations this would be check marked. The exception would be if you want to only enable the input when a Process is started/running.
|
Inverted – select if wired signal is inverted (contact always on - off trips the alarm).
|
On Delay – leave as default - causes a delay in milliseconds before the contact is turned on.
|
Off Delay – leave as default - causes a delay in milliseconds before the contact is turned off.
|
Linked To – leave this field as Not Set - this item will be addressed in Part # 3.
|