Overview
|
An Isolation Code is the specific channel used with a coordinator. Different Isolation Codes are required for facilities with multiple coordinators. New devices are shipped with a default Isolation Code of 1. There are multiple methods available to change the ISO code. This guide will explain how to change the ISO Code on a BSC, TIM or BSC using the Touch Screen. If you have a Call Station, please go to the Categories - Call Station page for instructions.
|
|
Requirements
|
1. The VT3000 Core Software installed and running on your system.
|
2. At least one Coordinator setup, powered and communicating with the VT3000 Core Software.
|
3. At least one BSC, TIM or PSM powered & communicating with the system.
|
|
Video
File:Change ISO Touch Screen.mkv
Instructions
Step 1.
|
Ensure the Touch Screen & IO Module are plugged in and powered.
|
|
Step 2.
|
Ensure the Bluetooth signal from the Touch Screen is active/connected.
|
|
Step 3.
|
Select the 3 dots in the top right corner of the Touch Screen next to the Time display.
|
|
Step 4.
|
Enter “7047” on the Pin Entry keypad – select OK.
|
|
Step 5.
|
Select Settings on the Touch Screen menu.
|
|
Step 6.
|
Scroll down the menu until you get to the Mesh heading - locate Isolation Code - select the Get button on the right side.
|
|
Step 7.
|
The current Isolation Code will populate in the field - select the Change button.
|
|
Step 8.
|
Enter the Isolation Code number that you want to switch to – select the Set button.
|
|
Step 9.
|
Device will refresh and show the new ISO Code. Exit the Settings on the Touch Screen by selecting the Back button at the bottom of the screen.
|
|
Step 10.
|
Open the VT3000 web interface – select VT3000 Core Software - log in – select Diagnostics – select Device Status.
|
|
Diagnostics |
Device Status
|
|
|
|
Step 11.
|
Find the device that you switched the ISO Code on - under the Network Name, ensure it is showing the correct name of the Coordinator.
|
|