Home - Call Station

Call Stations are hardware modules that have 4 fixed buttons.
These buttons can be configured as Alarms inside the VT3000 Core Software.
Alarms can be setup as Dual State or Tri-State.
This device is available as Powered (110vac) or Battery Powered (C Cell).

---

Select the appropriate link below for Instructions on Installation Instructions on Installing a Battery Powered Call Station Instructions on Installing a Powered (110vac) Call Station

---

Select the appropriate link below for a How To Guide Configuration Create/Add a new Call Station Configuration to your system Update/Send a Configuration to a Battery Powered Call Station Update/Send a Configuration to a Powered (110vac) Call Station Attached Light Stack Add/Attach a Light Stack to a Call Station Setup/Configure and Attached Light Stack on a Call Station Setup/Configure the use of an Attached Light Stack on a Call Station ISO (Isolation) Code Change the ISO (Isolation) Code on a Call Station using Buttons 1 - 4 Change the ISO (Isolation) Code on a Call Station using Device Status - Wirelessly Change the ISO (Isolation) Code on a Call Station using the Micro SD Card on the Device Signal Strength Test the Signal Strength (Mesh Signal) on a Battery Powered Call Station Test the Signal Strength (Mesh Signal) on a Powered (110vac) Call Station Firmware Update the Firmware on a Battery Powered Call Station - Wirelessly Update the Firmware on a Powered (110vac) Call Station - Wirelessly Update the Firmware on a Call Station using the Micro SD Card on the Device

---