Home - Call Station

From Versacall Support
Revision as of 12:59, 9 September 2022 by SupportAdmin (talk | contribs)
Jump to navigation Jump to search
Call Support at 858-677-6766 ext. 210
SubmitTckBtn.png EmailUsBtn.png


GeneralHeader.png

Call Stations are hardware modules that have 4 fixed buttons.
These buttons can be configured as Alarms inside the VT3000 Core Software.
Alarms can be setup as Dual State or Tri-State. Buttons can be disabled if not being used.
This device is available as Powered (110vac) or Battery Powered (C Cell).


InstallCS1.png InstallCS2.png










InstallHeader.png

Select the appropriate link below for Instructions on Installation
Instructions on Installing a Battery Powered Call Station
Instructions on Installing a Powered (110vac) Call Station




StepHeader.png

Select the appropriate link below for a How To Guide
Configuration - Alarms
Create/Add a new Call Station Configuration to your system
Configuration - Propgram/Update
Update/Send a Configuration to a Battery Powered Call Station
Update/Send a Configuration to a Powered (110vac) Call Station
Attached Light Stack
Add/Attach a Light Stack to a Call Station
Setup/Configure and Attached Light Stack on a Call Station
Setup/Configure the use of an Attached Light Stack on a Call Station
ISO (Isolation) Code
Change the ISO (Isolation) Code on a Call Station using Buttons 1 - 4
Change the ISO (Isolation) Code on a Call Station using Device Status - Wirelessly
Change the ISO (Isolation) Code on a Call Station using the Micro SD Card on the Device
Signal Strength
Test the Signal Strength (Mesh Signal) on a Battery Powered Call Station
Test the Signal Strength (Mesh Signal) on a Powered (110vac) Call Station
Firmware
Update the Firmware on a Battery Powered Call Station - Wirelessly
Update the Firmware on a Powered (110vac) Call Station - Wirelessly
Update the Firmware on a Call Station using the Micro SD Card on the Device




SearchHeader.png


VC Footer.png
Follow Us On LinkedIn View our Blog