Step 7.
|
Each wire will need to be connected to the output bar at the top of the circuit board. To connect the wire, insert it into the hole on the front of the output bar and tighten the screw on top of the bar. Below is a chart on where each wire should be inserted. If your light stack has a different order than the standard (Red, Amber, Blue, White, Green) feel free to arrange the wires on any output you wish except Yellow, it must be connected to 24V.
Yellow Wire - connect to the 24V output.
|
Red Wire - connect to the O1 output.
|
Amber Wire - connect to the O2 output.
|
Blue Wire - connect to the O3 output.
|
White Wire - connect to the O4 output.
|
Green Wire - connect to the O5 output.
|
|
|
|