Home - BSC

A BSC is a hardware module that has a Touch Screen & I/O Module.
A BSC can be programmed inside the VT3000 Core Software.
Alarms can be setup as Mono State, Dual State, and Tri-State.
Alarms can accept Reason Codes on Set, Acknowledge or Clear.
A Manual Count button can be programmed. Allows an operator to select the button to indicate a piece is complete.
A Process button can be programmed. Allows an operator to select the button to indicate when work began and when it ended.
The Device can accept a total of 2 buttons. (1) Process & (1) Count or (2) Count buttons.

---

Select the appropriate link below for Instructions on Installation Instructions on Installing a BSC I/O & Touch Screen Instructions on Installing a Replacement Touch Screen Instructions on Pairing an Existing Touch Screen

---

Select the appropriate link below for a How To Guide Configuration - Alarms Create/Add an Alarm Create/Add an Alarm Label Create/Add an Alarm with a Reason Code Add Communications to an Alarm Configuration - Process Create/Add a Process Create/Add an Alarm to a Process Create/Add a Data Field to a Process Configuration - Count Create/Add a Manual Count Button Configuration - Program/Update Send a Configuration to a New/Not Configured BSC Send an Updated Configuration to an Existing/Configured BSC Configuration - Data Field Create/Add a Key Input Data Field Create/Add a Shared List Data Field Create/Add a Static List Data Field Attached Light Stack Add/Attach a Light Stack to a BSC I/O Module Setup/Configure an Attached Light Stack Setup/Configure the use of an Attached Light Stack ISO (Isolation) Code Change the ISO (Isolation) Code using the Touch Screen Change the ISO (Isolation) Code using the VT3000 Software - Wirelessly Change the ISO (Isolation) Code using the Micro SD Card in the I/O Module - Manually Signal Strength Test the Signal Strength (Mesh Signal) Test the Bluetooh Signal Strength (I/O to Touch Screen Connection) Firmware Update the Firmware on a Battery Powered Call Station - Wirelessly Update the Firmware on a Powered (110vac) Call Station - Wirelessly Update the Firmware on a Call Station using the Micro SD Card on the Device

---